PLEASE NOTE: This document applies to an unreleased version of Rook. It is strongly recommended that you only use official releases of Rook, as unreleased versions are subject to changes and incompatibilities that will not be supported in the official releases.

    If you are using an official release version of Rook, you should refer to the documentation for your specific version.

    Documentation for other releases can be found by using the version selector in the bottom left of any doc page.

    Tectonic Bare Metal

    Here is a running guide on how to implement Rook on Tectonic. A complete guide on how to install Tectonic is out of the scope of the Rook project. More info can be found on the Tectonic website


    • An installed tectonic-installer. These steps are described on the Tectonic website
    • A running matchbox node which will do the provisioning (Matchbox is only required if you are running Tectonic on Bare metal)
    • You can run through all steps of the GUI installer, but in the last step, choose Boot manually. This way we can make the necessary changes first.

    Edit the kubelet.service file

    We need to make a few adaptions to the Kubelet systemd service file generated by the Tectonic-installer.

    First change to the directory in which you untarred the tectonic installer and find your newly generated cluster configuration files.

    cd ~/tectonic/tectonic-installer/LINUX-OR-DARWIN/clusters

    Open the file modules/ignition/resources/services/kubelet.service in your favorite editor and after the last line containing ExecStartPre=..., paste the following extra lines:

    ExecStartPre=/bin/mkdir -p /var/lib/kubelet/volumeplugins
    ExecStartPre=/bin/mkdir -p /var/lib/rook

    And after the ExecStart=/usr/lib/coreos/kubelet-wrapper \ line, insert the following flag for the kubelet-wrapper to point to a path reachable outside of the Kubelet rkt container:

    --volume-plugin-dir=/var/lib/kubelet/volumeplugins \

    Save and close the file.

    Boot your Tectonic cluster

    All the preparations are ready for Tectonic to boot now. We will use terraform to start the cluster. Visit the official Tectonic manual boot page for the commands to use.

    Remark: The Tectonic installer contains the correct terraform binary out of the box. This terraform binary can be found in following directory ~/tectonic/tectonic-installer/linux.

    Start Rook

    After the Tectonic Installer ran and the Kubernetes cluster is started and ready, you can follow the Rook installation guide. If you want to specify which disks Rook uses, follow the instructions in creating Rook clusters